Page 9
Figure 1 – Side panel thumbscrews Figure 2 – Rotate smaller panels outward Figure 2 – Rotate smaller panels to and remove the bottom hinge first remove Figure 3 – LanBoy Air with side panels removed...
Page 14
Figure 18 – PSU mount screw locations Figure 19 – Removing the motherboard tray rails Figure 20 – New rail positions...
Page 15
Figure 21 – PSU mount screw locations Figure 22 • • Figure 23 – Make sure you have the correct I/O panel. This mismatched I/O panel can cause difficulties down the road.
Page 16
Figure 23 – Motherboard tray with motherboard Figure 24 – Motherboard tray with preinstalled standoffs and additional standoff holes identified Figure 25 – Screwing in the motherboard after standoffs are installed...
Page 17
Figure 26 – Reinserting the motherboard tray Figure 27 – PSU in mount with screws identified...
Page 20
Signal Names Signal Names USB Power 1 USB Power 2 Negative Signal 1 Negative Signal 2 Positive Signal 1 Positive Signal 2 Ground 1 Ground 2 Key (No Connection) Empty Pin 9 10 Signal Names Signal Names (HDA) (AC’97) MIC2 L MIC In AGND MIC2 R...
Page 21
Figure 29 – Attaching the front panel ground wire Figure 30 – Front panel leads...
Page 24
Standard fans on the LanBoy Air: A –2 x 120 mm front variable speed fans B – 2 x 120 mm side TwoCool™ fans C – 1 x 120 mm rear TwoCool™ fan ™ LED F Figure 32 – Rear fan control panel...
Page 25
LED F RONT ANS WITH ARIABLE PEED ONTROL Figure 33 – Fan speed adjustment knob...
Page 26
PTIONAL Optional fan mounts on the LanBoy Air: A –2 x 120 mm large side panel fans B – 6 x 120 mm small side panel fans (3 x per side) C – 2 x top 120 mm fans ATER OOLING Figure 34 –...